An integrated amplifier of the highest aesthetic, technical and audio reproductive quality. Beautiful, simple and functional by design. As easy as childs play to operate. Resourceful enough to hold the most power-hungry speakers in a viselike grip, yet at the same time musical, respectful and authentic.

Teaching it to sing

Thousands of hours have passed while «voicing», a process where each and every component has been carefully selected and optimised to ensure that the AMP-150 does not leave any fingerprints on the music. The way the AMP-150 plays is therefore quite unusual; aurally, this is about the closest you can get to a straight wire with built-in amplification.

Pure Power!

With more than 250W RMS @ 4ohms available in each channel, the AMP-150 delivers more than enough voltage to avoid clipping in the high peaks, offering loads of headroom and musical freedom.


  • Balanced and unbalanced inputs
  • TwinFET technology output stage
  • High bandwidth power supply
  • Full metal remote control (RC-1)
  • Analogue multi display, clear and informative
  • Nonmagnetic enclosure
  • Pre-heat circuit
  • Direct function; enables use in home theater sytems
  • Designed, developed and build in Copenhagen, Denmark


Technical stuff

Output power (230 VAC) 2x 150 W RMS 8 Ω / 2x 250 W RMS 4 Ω
Input impedance 20kΩ RCA or 40kΩ Balanced
Frequency response 20 Hz – 20 kHz ± 0.5 dB, and 2 Hz – 100 kHz ± 3 dB
Preamplifier output impedance 100 Ω RCA and 200 Ω Balanced
Total Harmonic Distortion < 0,05 % at rated power
Signal to Noise ratio A-weighted > 100 dB
Voltage gain 27 dB (+10 dB headroom)
Recommended speaker load 4 Ω – 16 Ω
Load protection Speakers < 1.5Ω


Balanced analogue inputs 1 pair gold plated XLR Neutrik
Unbalanced analogue inputs 4 pairs of gold plated RCA Stereo
Balanced analogue outputs 1 pair gold plated XLR Neutrik
Unbalanced analogue outputs 1 pair of gold plated RCA Stereo
Speaker output 2 pairs of gold plated safety banana

Size & Power

Power Requirements 115 VAC or 230 VAC, 50 Hz or 60 Hz
Fuse 20mm Sand filled, 6 AT@115 VAC, 3.15 AT@230VAC
Power Consumption Standby <1 W, Idle < 40 W, Heat <200 W, Max is 600 W
Soft start Surge current at startup is < 10A
Weight 13.8 kg / 30.4 lb